IPDB › China Industry › Chemicals
China, Chinese Emergency Repair Adhesive for Conveyor Belt1 Industrial Products Supplier Manufacturer Details, price list catalog:
China Industrial Products Supplier Manufacturer List Catalog
Chemical Auxiliary CatalystSurface Disposal AgentEmergency AdhesiveRepair Adhesive
Shanxi Beiguo Science and Technology Co., Ltd
Preview:
Product Description Product Usage1. Rapid repair of defects such as longitudinal tearing, holes, scratches, and adhesive peeling on conveyor belts.2. Aging repair of the working layer of the belt (main shaft belt);3. The belt buckle at the joint of the conveyor belt is wrapped with glue;4. Repair of working and non working layers after tearing of conveyor belt;5. Repair the sealing of the conveyor belt after excavation and repair;6. Partial penetration repair of conveyor belt;7. Repair the sealing of the joint after cold vulcanization bonding of the conveyor belt.Usage:1. Place the area to be repaired in a horizontal position, clean the area with a brush, and cut grooves or make steps around the area to be repaired.2. Use an angle grinder to roughen the surface to be repaired, and clean the repaired surface with a brush after polishing.3. Seal the possible leakage areas with adhesive tape.4. Then use a brush to evenly apply the surface treatment agent to the polished surface to be repaired, and let it dry.5. Load the two-component adhesive into the spray gun and start repairing.6. Compact the repaired surface, scrape it flat and wait for several hours. After the surface hardens, it can be turned on for use.7. The operation time is 60 seconds and the curing time is 2 minutes.Notes:1. When the temperature is below 0 oC, the working surface must be baked with an iodine tungsten lamp to increase the temperature of the repaired adhesive surface.2. The curing time of the product may vary due to changes in external temperature, and it is normal to extend the curing time appropriately at low temperatures.3. When the external temperature is lower than 8 oC, there will be gel phenomenon. It can be used normally after being placed in a room with a temperature higher than 25 oC for degumming.4. In the early stage of mixing the rubber material, there may be about 1/5 of the pipes mixed unevenly, and the unmixed rubber material should be removed during use.5. It must be thoroughly mixed, otherwise there may be situations where it cannot be cured.6. After separating groups A and B, they should be used up as soon as possible and cannot be stored.7. Avoid contact with eyes and nostrils before curing. If accidentally touched, rinse immediately with water.8. This product is non flammable and should be stored in a cool and dry place.
Purchasing Request
Note: Send your purchase request, and we will screen suppliers or manufacturers for you free of charge...